EMRP: Reports to Process

Can't be bothered to update all those EMRP pages by yourself? Then don't. Let the EMR Bot do it for you.

You can paste entire batches of reports from your events log onto this page. It takes just one edit here rather than two (or more) per report if you do it manually. Just follow the instructions below.

Adding Reports

Correct Formatting is VITAL!

Adding a Batch of New Reports

Create a level 3 heading with 5 tildes as the title, this will insert a timestamp. Like this but without the brackets: (===~~~~~===). Paste your reports underneath this new heading.

Take Note of these Points

-- If there are no reports to process, remove any comments under the "Reports to Process" header when you add more.

-- Avoid posting duplicate reports where possible. Check the recently processed list at the bottom of the page.

-- If the reports are old enough that the timestamp isn't that accurate, sign with 5 tildes anyway, save, then edit the timestamp.

Example

Here's an example of what the page code should look like after you save it:

==Report to Process==

===18:18, 2 July 2008 (BST)===

25.96 MHz: "... leaving Reganbank, counted about forty outside ... they're just wandering around ... can't see any signs of life ... the whole suburb's wrecked ..." (5 hours and 36 minutes ago)

===14:18, 4 July 2008 (BST)===

25.96 MHz: "... reporting from Pashenton, I've got twenty or so active ... they're just wandering around ... lights are on across the suburb ... infrastructure looks intact too ... the Lance Building has power ..." (19 hours and 36 minutes ago)

25.96 MHz: "... can see about eighty on the streets of Ketchelbank ... a few big groups, but they're spread out ... a few buildings with lights on ... serious collateral damage ..." (17 hours and 56 minutes ago)

Reports to Process

List processed on: 03:31, 22 September 2010 (BST)

Recently Processed

03:30, 22 September 2010 (BST)

25.96 MHz: "... reporting from Brooke Hills, I've got a couple of dozen active ... mostly just small groups ... several buildings with power ... some minor structural damage ... the Heathcote Building is being held ..." (18 hours and 27 minutes ago)

25.96 MHz: "... Pimbank is still active, about forty on the streets ... mostly just small groups ... a few buildings with lights on ... heavy structural damage ... Tynte Mall has fallen - repeat, Tynte Mall has fallen ..." (9 hours and 47 minutes ago)

25.96 MHz: "... flying over Fryerbank, can see about sixty on the streets ... a few big groups, but they're spread out ... a few buildings with lights on ... most of the buildings are ruined ... Joachim Mall has lights on ... the Longstaff Building is down ..." (6 hours and 27 minutes ago)

25.96 MHz: "... leaving Richmond Hills, counted maybe fifty outside ... a horde of twenty or so outside St Mark's Hospital ... a few buildings with lights on ... serious collateral damage ... the Laimbeer Building has lights on ... looks like the Lockwood ..." (3 hours and 47 minutes ago)