EMRP: Reports to Process
Can't be bothered to update all those EMRP pages by yourself? Then don't. Let the EMR Bot do it for you.
You can paste entire batches of reports from your events log onto this page. It takes just one edit here rather than two (or more) per report if you do it manually. Just follow the instructions below.
Adding Reports
Correct Formatting is VITAL! |
Adding a Batch of New Reports
Create a level 3 heading with 5 tildes as the title, this will insert a timestamp. Like this but without the brackets: (===~~~~~===). Paste your reports underneath this new heading.
Take Note of these Points
-- If there are no reports to process, remove any comments under the "Reports to Process" header when you add more.
-- New batches of reports should go under older batches, to maintain chronological order.
-- Avoid posting duplicate reports where possible. Check the recently processed list at the bottom of the page.
-- If the reports are old enough that the timestamp isn't that accurate, sign with 5 tildes anyway, save, then edit the timestamp.
Example
Here's an example of what the page code should look like after you save it:
==Report to Process== |
===18:18, 2 July 2008 (BST)=== |
25.96 MHz: "... leaving Reganbank, counted about forty outside ... they're just wandering around ... can't see any signs of life ... the whole suburb's wrecked ..." (5 hours and 36 minutes ago) |
===14:18, 4 July 2008 (BST)=== |
25.96 MHz: "... reporting from Pashenton, I've got twenty or so active ... they're just wandering around ... lights are on across the suburb ... infrastructure looks intact too ... the Lance Building has power ..." (19 hours and 36 minutes ago) |
25.96 MHz: "... can see about eighty on the streets of Ketchelbank ... a few big groups, but they're spread out ... a few buildings with lights on ... serious collateral damage ..." (17 hours and 56 minutes ago) |
Report to Process
19:06, 26 July 2009 (BST)
25.96 MHz: "... flying over Gulsonside, can see about forty on the streets ... all stragglers, no groups ... can't see any signs of life ... heavy structural damage ... the Perryn Building is out of action ..." (5 hours and 44 minutes ago)
25.96 MHz: "... reporting from Brooke Hills, I've got about forty active ... a few outside Grandon Place Police Dept ... a lot of buildings with lights on ... some minor structural damage ... the Heathcote Building is operational ..." (5 hours and 4 minutes ago)
25.96 MHz: "... flying over Crowbank, can see maybe fifty on the streets ... maybe a dozen outside Burt Square Police Dept ... several buildings with power ... serious collateral damage ... lights are on in the Blocksidge Building ..." (4 hours and 24 minutes ago)
Recently Processed
09:28, 26 July 2009 (BST)
25.96 MHz: "... Dartside looks clear ... a lot of lights on, looks the area's been reclaimed ... infrastructure looks intact too ... the Bagnall Building is being held ..." (6 hours and 46 minutes ago)
25.96 MHz: "... leaving Peddlesden Village, counted a couple of dozen outside ... mostly just stragglers, no organised groups ... no lights on down there ... heavy structural damage ..." (5 hours and 26 minutes ago)
25.96 MHz: "... leaving West Boundwood, counted about forty outside ... mostly just stragglers, no organised groups ... several buildings with power ... heavy structural damage ..." (4 hours and 25 minutes ago)
25.96 MHz: "... a couple of dozen in Crooketon ... they're just wandering around ... a few buildings with lights on ... serious collateral damage ..." (26 minutes ago)